The "clean shield" of the power system - Mitsubishi Filter MM320-88601
In the power and hydraulic systems of construction machinery and vehicles, the cleanliness of the oil directly determines the service life and reliability of the equipment. As an original factory-certified component, the Mitsubishi filter MM320-88601, with "precise matching + deep purification" at its core, builds the first line of defense for the system.
1. Original factory compatibility: Eliminate system risks
This filter is specially designed for the designated models of Mitsubishi (for specific compatibility, please consult customer service). From the sealing interface to the size of the filter cartridge, it fully conforms to the original factory oil circuit/hydraulic circuit. Unlike the "forced compatibility" of general-purpose filters, it seamlessly matches the system pressure and flow rate, avoiding oil leakage and pressure loss caused by adaptation deviations - this is particularly crucial for high-pressure hydraulic systems, as it can prevent the response delay of actuating elements (such as cylinders and motors) and ensure the accuracy of equipment operation.
2. Multi-layer filter materials: Intercept "Invisible Killers"
It adopts a gradient composite filter material design: the outer layer intercepts large particles such as sand and metal debris, the middle layer adsorbs the gum produced by the oxidation of oil, and the inner layer filters micron-level impurities. Even in dusty construction sites and long-term heavy-load transportation scenarios, it can still maintain stable filtration efficiency, ensuring that the cleanliness of the oil always meets the original factory standards. This purification capacity directly reduces the wear of precision components such as pistons and valve groups, and slows down the aging speed of the system.
3.The hidden value behind durability
Ordinary filters are prone to filter paper damage and seal failure due to high pressure and corrosion. However, the housing of MM320-88601 is made of anti-aging engineering plastic, and the sealing rubber ring is made of oil-resistant rubber. It has been tested and can withstand continuous operation for more than 3,000 hours. Over long-term use, it not only reduces the frequency of oil replacement but also minimizes system failures caused by impurities - the cost of maintaining a hydraulic pump is much higher than the investment in multiple sets of original factory filters.
Maintenance suggestions: It is recommended to replace the equipment every 2,000 hours or in combination with the equipment maintenance cycle (in harsh working conditions, advance replacement is necessary). When replacing, it is advisable to choose original factory parts first to avoid "secondary pollution" of the system due to differences in filter materials.
Common models, accessories, and diesel engine filters for Mitsubishi diesel generators in Japan: 8 DC7、8DC8、8DC9、8DC11、10DC、S4E、S4E2、S4Q2、S4S-T、S4K-T、4DQ5、ADQ7、4DR5、4G15、4G32、4G33、4G41、S6K、S6E、S6S、6D15C、6D16、6D16-T、6D22-T、6D22-TC、6D24、6DR5、S6B-PTA1、S6B-PTA2、S6B3-PTA、S6A-PTAA、S6A3-PTAA、S6R-PTA-S、S6R2-PTA、S6R2-PTA、S12H-PTA、S12R-PTA-S、S12R-PTA2、S12R-PTAA2-S、S16R-PTA、S16R-PTA2、S12R-PTAA2-S
